Danco 10879X All-In-One Toilet Installation Kit

This product delivers what it's being advertized for. It is reusable and can be forgiving if not aligned properly as it can be re-aligned during installation process. The wax seals into the flange and the rubber portion seals the toilet outlet which is better than set-rite I used in my other toilet with the same issue with flange being below the floor level. I highly recommend this product as this is cheaper. Just make sure you read and follow the installation instruction closely both from the instruction guide that comes with it and online.

As an engineer there are some things that come naturally. I'm great with electricity, AC, DC, PV, load panels, 240VAC, split-phase, 3-phase (delta or wye), transformers, datacenter UPSs, HVAC systems, etc. BUT PLUMBING NEVER WORKS FOR ME AND IT ALWAYS ENDS UP LEAKING!!!! So in preparation for replacing an old Toto that was a bear to clean (once a week due to poor design) and wouldn't stop leaking no matter what flapper I put in (and even sanded the inside rim) I watched a bunch of YouTube videos. The ones with detail done by professionals recommended this kit. So I got it. (Also "flapper" is the new name for "ballcock.") WHAT IS GREAT ABOUT THIS: The directions are so well written if you can read pictures you can do this. You can also watch the videos. They included almost every part or piece I'd ever want EXCEPT no shims. You can get shims for $4 at Amazon, HD, Loew's, ACE, TruValue, etc. If you don't want store-bought shims you can use a rubber door stopper triangle and cut it just right. Everything I needed was there, and the instructions were clear, so I had cut the old caulk, removed the toilet, removed the gunky wax seal and stuff ahead of time. I measured as per the kit and didn't need the "blue part" since the level of the flange was above floor height. Took it off, put it aside, never used it. The alignment rods are perfect. I've watched videos of people trying to align the two bolt holes while moving the 80-100lb toilet. Having the two rods marking where to put the bolts in and positioning the toiler so the blue rods stuck out of the holes in the toilet base was TRIVIAL. Then, I removed the blue rods (just pull them out, no friction, no screwing) and put the bolts in. Hand tighten using the plastic grommets. No crescent wrench no channel-locks no torque wrench (they warn you not to overtighten or the porcelain breaks). Hooked up the water and the bidet seat. No leaks!!! My first plumbing job with no leaks, and it was a toilet r/r -- the toughest job excluding the under-sink garbage disposal. The toilet appeared stable but when I sat on it there was a bit of a wobble. Tightening the bolts is not the right answer if they're already hand tight. More YT video and went and got shims. Put them in, wobble gone, cut just shy of the toilet base rim so caulk would hide it, and that was done. Caulked for completeness but not in the back, cleaned it up with a credit card (better than a wet finger because it shoves the caulk into that rounded slot between the toilet base and the floor) and it was good. It's been three plus weeks and it's all perfect. Was it worth the price to get it done RIGHT, THE FIRST TIME, not worry about alignment, and have no leaks? YES YES YES. Great product. Great price. Job done right first time. DIY heaven.

Good

Excelente producto.

No es posible usar cuando la brida está a nivel de piso quedando demasiado alta