YESWELDER Magnesium Aluminum Welding Wire, ER5356 | 0.030 in on a strong ABS spool for smooth feeding, handling and storage

Wire works great flat and down hill. Uphill might just be out of my wheel house. Overall, I would buy again.

Great quality wire !!! Welds like a dream

Runs well in my Vulcan Omnipro 220. The local Harbor Freight is often out of the 5356 wire. So I ordered this just in case. I've heard it runs better than the Vulcan wire. But I find it to be about the same. Seems a little brighter though. But that could be my imagination. I run it at the same voltage and wire speed as my Vulcan wire. Good substitute though.

This mig wire is a good alternative to those more expensive wires. Makes a good weld, as long as your settings are right.

This wire was an experiment to see if my cheapo mig machine (HF) would weld aluminum. I have tried tig welding aluminum, but very tricky and learning curve to achieve good results long. So, I decided to try the mig route. Some process notes: Clean, clean, clean......the material first with a dedicated stainless steel brush, then wipe down with acetone. Use 100% argon gas 25-30 cfh, set feed speed higher than your used to with mild steel and be prepared to push feed quicker than your used to. I also preheated a bit with propane torch. Amp setting will have to be experimented with but I got good looking welds with good penetration on 1/8 inch material at about 75 amps. I had no trouble at all with feeding the .035 wire using a 10 ft lead, but keep it as straight as possible to avoid kinking the wire. Very satisfied with product.

fast service, everything it should be, thank you

Yes for win. This is my go to for my aluminum spool gun now. Good on new and use aluminum.

So it worked for holding it. But i haven't put it to the stress test yet. We'll see

recommended by the HZXVOGEN 250A mig welder , but doesn't work that good on 6061 aluminum .the forney 42296 wire works better

Trop cher moitier prix local