Rust-Oleum Appliance Touch-Up Biscuit Paint | Scratch Repair, Chip Repair, Porcelain And Metal Surfaces, Precision Brush Applicator, 0.6 Oz

The “Rust-Oleum 213174 .6-Ounce Specialty Brush Bottle Appliance Touch Up, Black Glossy” arrived promptly and was better than described online. PROS: (No CONS observed.) * I chose this high-quality, dependable Brand “Rust-oleum Black Glossy Appliance Touch-up” to repair a large chip measuring 3/4” x 1-1/4” on the front edge of my black porcelain stovetop. * EASY-to-USE with PERFECT RESULTS! Appliance Touch-up can be applied to metal, porcelain and enamel surfaces. It is a quick-drying acrylic lacquer that provides a long- lasting , high-gloss finish. * Quick-dry feature makes it useful on daily used stoves, refrigerators, washers, dryers, dishwashers and more. * Apply on exterior surfaces only in places where temperatures do not exceed 200°F. * Use in well-ventilated areas - open the windows during use. * Instructions on the back of the package are easy to follow: Begin by shaking the 0.6oz bottle to mix contents well. (1) Clean the scratched or chipped surface with soap & water. Dry thoroughly. I applied a final wipe with rubbing alcohol after that. (2) apply Appliance touchup in even strokes using the tapered brush attached to the bottle lid. (3) for deep scratches or chips apply multiple layers. (4) allow to dry for 10 minutes between coats. (5) for best results allow to dry overnight before use. (6) while still wet, clean up any excess or mistakes with lacquer thinner, rubbing alcohol or acetone. (7) Extend the brush strokes slightly beyond the scratch or chip for best results. * My stovetop is covered with a large Amazon Silicone rubber protective mat. This mat protects the stovetop from spills and droppings from the microwave directly above the stovetop. However the edges of the stovetop are not covered by the mat. A dish fell from the microwave causing the huge chip on the stovetop’s front edge. Dependable Rust-oleum to the rescue! * Manufactured in the USA 🇺🇸! Enjoy your newly repaired appliance! Highly Recommended.

I purchased this to touch up a porcelain sink, as well as some rust spots on a fridge. It worked well. It does smell strong--like nail polish, but it dried quickly and the fumes aren't overwhelming. This paint worked really well on the sink and matched well. However, it was definitely brighter than the white fridge I used it on, so now, instead of having a zillion tiny rust spots, it has a zillion tiny white spots. I guess it's the better option. For the money, it was a good solution.

Works well, it looks like an old bottle of white out. The reason for only 4 stars is because of the brush. It is small and not very high quality which means that the streaks of paint that go on are not great.

Relatively simple process, like painting nails with two thin layers. Good enough result, see picture. There's a large chip in this range's enamel and the dark steel was bare. Previously used another epoxy claiming to fix it, looked like we put a chewing gum on. Terrible. So we scratched it off again, carefully, with a cutter and used this on the now slightly bigger spot. One thin layer started throwing waves when we tried to wipe the edges thinner with isoprop maybe 30sec after application. Removed the entire, half-dried layer again, an easily job with cottonball and acetone. Started over. Two thin layers, maybe half an hour apart, make our formerly obvious damage truly inconspicuous. Not invisible on close inspection, color is slightly mismatched and surface at interface shows a bit. But looks great from a normal distance and draws zero attention. Tries super hard, but could be gently smoothed with knife edge. Will last the appliance's lifetime. This, chewing gum epoxy, is how to do it. Optically the unit is ok, it won't rust and the bottle's almost full. We's also treated spots on other appliances now. It's a little like nail paint. New appliance vs this? Good value!

I dinged my semi-industrial sewing machine (dropped a metal seam guide on it) and damaged an area of my ikea tabletop and this paint covered both PERFECTLY. I used my own tiny paint brush to apply since I’m a perfectionist and it worked well. Dries fast, and is easy to layer. I’m relieved that it blends in on both a white wooden desk and a white coated metal sewing machine. I highly recommend this.

This worked surprisingly well on some small scratches in the metal trim of our stove. Great product

I misread the contents. It is .6 ounces not six ounces. Product is good for a tiny chip or scratch. I ended up at the hardware store for a larger quantity.

Does everything it was advertised to do. Helps to mask a chip mark on t stove top bezel. Fast drying acrylic - ~ 10 minutes a described, with one application doing the job. May try a 2nd layer to even out the chip site. Was as described (and use with proper ventilation). Arrived in good condition. Easy to apply with cap brush and small bottle. Low cost.