RecPro RV Aluminum Table Support Trim Mill Finish 30" | RV Trim | RV Table Support | for Sliding Table Support | Made in USA

I wanted to make my chinook capable of making another bed. I made the club chairs quick release and added a 24x24 table using this bracket. Works great table is strong and stable and easy to change to a bed.

The media could not be loaded. We bought this for installing a folding table in our DIY no-build minivan micro-camper and it works well, my only suggestion is to make sure that both parts are installed on perfectly leveled surfaces. In my case my cabinet has a slight bulge in the middle section so it takes some effort to install the table and slide it back and forth. The aluminum rail that goes on the cabinet is not very strong so it can flex while installing. Again this is all because of my limited carpentry skills and not the product fault - just a suggestion for someone going to install it.

When you driving an old RV the dining table is shaking on the rough road, decided to install this product, remove and throw away old one, attached new one to the table and to the wall, check your level, put together. No shakes, ease to use

Looks good but I cant get the table hooked in without dropping in and scratching the wall. Once secured, table don't wiggle.

Easy install and holds tight and secure

I will use it for a shelf on the exterior of my trailer. It will work out GREAT. Thank you

Used to make a removable shelf inside my rv.

Works great for adding a table to my existing track on my Jayco pop up camper