INJORA 540 Brushed Motor 35T Waterproof Motor for 1/10 RC Cralwer Car Axial SCX10 Pro SCX10 AXI03007 90046 TRX4 D90 Monster Truck （35T）

I use this motor to power a 3d printed model tank that I built. It’s a super high quality motor with plenty of power. I soldered the wires to the motor + and - terminals and it works reliably.

I am very surprised regarding the durability and quality of this motor at the price paid. Overall, the Injora brushed motor is an outstanding value. This is a very dependable product and highly recommended. Comparing performance with my other motors, the 13T Injora motor exceeded expectations. With this motor (with a 30 tooth pinion gear and 68 tooth drive gear with a 500ma NIMH battery) my TT-02 went through a 100 meter straight track in 3.65 seconds. This motor will produce insane speeds; however, I highly recommend a heat sink.

Got two of these to revive my old closbuster stick crawler. I was very pleased with the quality of these motors, loads of power and the dont get super hot. For the price you can't beat them. They also came with some body sweet body stickers

Ok motor for a crawler and a 80 amp esc

Motor went up in smoke for a minute but now it works like it should

I burnt one of these up with a Spektrum 40 amp 2/3s brushed esc within minutes and 2s on my DEERC.

I ordered two of the 55t for a crawler project. The motors sat in a box for a few months waiting to be used. When I finally got them installed i fount only one motor worked. The dead motor has an internal ring that connects the can to the endcap. The screw holes were not stripped, but machined slightly too big so the bolt could not be secured allowing the end cap and timing to rotate. Emailed injora customer service and was told it was out of warranty. Not impressed with this motor and would not recommend. Wasted money

I think It’s more the 3 slot design than the actual product, but it sort of slightly skips and jumps in slow speed crawling and just doesn’t crawl as slow as my 5 slot. Mine also has little pits in the copper rotor where the brushes contact, so that could be causing it to not be smooth as well. Either way just not quite up to expectations, I’d much rather have the smoothness and slow speed startup of a 5 slot and give up the slightly stronger brake than have it feel cheap and choppy the entire time I’m slow crawling. Going back to a 5 slot.

I got a closed end can that's 550 in size not 540. I ordered 2x 540 and got 2x 550 motors. So expect the same if you purchase these. Atleast they got the 35T right?

Good price for a brushed motor, was a nice replacement I needed. Installed works great.

Top und Extrem schnell💪💪💪

This motor is awesome for my newest project.

Bestens