AC Infinity AIRPLATE S7, Quiet Cabinet Cooling Fan 12" /w Speed Controller

Absolutely love this product. So I currently have a large corner desk, one end of the desk is a cupboard which acts as the support to hold up the desk. This cupboard was evidently intended to house a computer as there's a cutout in the thin board at the back of the cupboard however, the temperature gets quite toasty in there so for a few months I used it just for my tool boxes. I then built a small media server/file server to run Plex and uTorrent 24/7 as well as handle backups for all my devices. I decided I wouldn't need physical access to this device often and since I wanted to leave it running 24/7 it had to go somewhere quiet and non-disruptive. So I decided to place it in this cupboard, I also put my xbox one and xbox 360 in there too, as well as my network switch and my new Linksys WRT1200AC router. So it's quite a packed cupboard but gives me easy access to the devices if I need to, without taking up precious desk space and causing an eye sore and an ear sore. The biggest dilemma with this setup was the heat build up in this cupboard. With only a small gap above the cupboard door and the small hole in the rear for cables, it didn't take long to heat up. Enter the AC Infinity AIRPLATE S7. I had considered doing a bit of a DIY job and simply re-purposing 2 computer fans and a mesh filter of some description and wiring them up and mounting them on the back of my cupboard but it all seemed a bit too much work as I'm not the best when it comes to wood work and soldering so I began hunting, I found the AC Infinity and it suited perfectly. It arrived with a small paper template to guide me where to cut and drill holes to install it, the fans etc. came pre-assembled so it was a simple case of drilling the holes and the cutout and popping it in, then plugging it in (via the USB power cable), switching it on and away it went. I plugged it into my xbox one initially since that was the biggest cause of heat so whenever the xbox turned on, the fans turned on too, however I decided I wanted to keep the cupboard extra cool for all my devices so I plugged it into my media server and It's been left on for over 5 months now without a single hiccup. The cupboard remains cool even with an Xbox One cranked up, a surprisingly warm router, and my media server all packed into a small side cupboard. The fans make short work of it and are nearly impossible to hear when the cupboard door is shut. The rear of the cupboard is just to the side of my bed and I can barely hear the fans, they are absolutely fantastic in terms of noise levels and also manage to shift a great amount of air whilst keeping quiet. I am so very happy with my purchase, if I ever build a small home theater setup, an AC infinity airplate will be at the top of my shopping list to keep everything cool and quiet. For this use I decided to go for the simple USB setup and not the touch screen panel simply because I couldn't be bothered cutting more holes. For my use case, I want it turned on and left on so the small screen was not necessary. However, if I were to build a home theater setup I would definitely grab the screen and mount it on the side of the TV cabinet. Again, cannot praise this product enough. If you've got a cabinet or cupboard, or even a drawer where you keep devices or items that get warm then this product is the one for you. Quiet, power efficient and very effective at cooling. Not to mention cost effective too!

Attention Tent Owners This is my third AC infinity product. I have previous purchased two ac infinity intake/outtake exhaust fans which btw are great and still in use one year later. My purchase: Ac infinity dual fan wallplate/airplate with the switch non-controller version. My application: pull cool air from the room into a 3x3 to keep the plants inside at optimal temps. Normally temps inside are acceptable at 80-82 degrees, but in flower I want to get several degrees lower to simulate fall/harvest. Why I needed it? I use an LED that at its highest settings putting off quite a bit of heat into a small space and although a great LED, too big for the space (bigger isn’t always better) so I was having difficulty dialing in temps even in my mostly automated small space. Full disclosure - I’ve purchased more than my fair share of fans over the years from amazon and other big box retailers. Some I still use, some shelved, others recycled or returned. Rather than setup a proper intake using another ac infinity intake I went ahead and tried fan after fan propped against the side of the tent with the flap open to force cool air in. Btw the inexpensive Amazon basic floor fan pushes a lot of air, but I digress. And This method works, but adds additional noise and light leakage both in and out of the tent (night/day). As you know, this is a problem and will result in confused plants or worse, herms. That said, I’m still lazy, seeking the easiest cheapest way and I’ve been so pleased with my other ac infinity products (I decided on this unit after measuring my tents side mesh window which was close enough) it was an easy decision to take a flyer on this dual fan airplate. This fits my 3x3 bottom mesh vent exceptionally well. I didn’t even have to use the included screws or zip ties that’s how snug it is. Perfect even. I simply used a boxcutter to cut out the mess in my tent and forcefully pushed the plate into place. This admittedly took some extra elbow grease, but once i got it in, I’d say its the middle cup of porridge, just right. This airplate on its highest setting I am able to keep my homes air set to 70-73 and allow for cool fresh air to enter the airplate/tent and force the hot air generated from my LED out of the top. My ac infinity outtake fan is pulling that hot air set on low with a controller (setting 2) through an oversized filter from another company to filter any smell (none) back into this spare bedroom. Added some pics. I opted to go with the non-controller version of the dual fan airplate as I have two other intake/outtake fans (ac infinity) with the controllers and thought it would be overkill. The airplate has a small switch on it with 4 settings. Off, low, medium & high. On high, it’s quiet and mostly unnoticeable and pushes enough air into tent to keep the perfect temps! Surprised me for an airplate that it was able to push as much air in as it does. Pros -perfect size for my application -quiet even on its highest setting -always on feature (using a smart app controlled outlet to turn off and on) -moves more air than expected -great engineering as usual Cons Not sure it’s a con, but it would have been better in white rather than black and without the controller I don’t know if it was possible to push even more air in on possibly higher settings. White was unavailable. That’s it, hope this helped some folks. Thank you AC Infinity

AC Infinity has always done right by me and this is no exception. I bought this fan because I installed a mini fridge in a kitchen cabinet. I had drilled out some ventilation holes but they weren't doing enough to get the fridge to work properly. I installed this fan and it did the trick. The quality of their products is second to none. Even the packaging gives you a feeling of quality and it's just cardboard. The product itself looks great and works just as described. It comes with a template to cut out any of the wall or cabinet where you are installing it. The fans run ultra quiet and are very smooth. It comes with a USB or power adapter. I opted for the power adapter to make sure that it was getting the correct amount of power to make sure that it was working as it needed to. I have the fan on high and you can't hear it at all. Moves plenty enough air for my needs. There aren't any cons to this product. The price is extremely reasonable so don't even bother looking anywhere else.

I bought the AC Infinity AIRPLATE S7 cooling fan system for a DIY cat litter box ventilation setup, and so far it has worked well for what I needed. The fans are quiet, which was one of the biggest things I cared about. I did not want something loud running in the background all the time, especially for a small home project. The airflow is good enough for my setup, and the speed control is useful because I can adjust it instead of having the fans running full blast all the time. The build quality feels solid, and the unit looks clean once installed. It is made for home theater or cabinet cooling, but it also works well for DIY ventilation projects if you need controlled airflow in a small area. Installation was straightforward, and the functionality is exactly what I needed. For value for money, I think it is a good buy. It is not the cheapest fan setup, but it feels better than trying to throw together random cheap fans and hoping they last. Would I buy it again? Yes. Good fans, quiet operation, useful speed control, and it worked great for my DIY cat litter box fan setup.

Works great just got to know what size you need and go from there. Very easy to install it’s dummy proof! Needed it because my PlayStation was getting extremely hot sense it was in a closed off cabinet. Would need to leave the doors open for air to flow but was annoying so this helped now it no longer hot at all ! Quite fan for the most part can’t complain. Money well spent. Need to make sure you get the same fan size if you get two. Also need an in and out flow. So two are a must when buying singles or doubles. The loud noise is the back thing on my Ps5. Overall great product hasn’t failed me

great product!

Think outside the box. I have a small addon room that needed air conditioning. Instead of a window unit or minisplit, I mounted this out of sight and use it to push conditioned air into the room.

Outstanding cabinet fan. It is dead quiet and runs smooth. I have a mac pro (round tube server) and a Raid Controller installed inside of a cabinet and use this fan to keep the components from melting. Anyone uses a mac knows how hot they get. This fan pulls the hot air out of the cabinet keeping the inside the same temp as ambient outside of the cabinet no problem. Just couple of tips I discovered during installation. The fans by default blow in, not out of the housing by default. In other words, if you look at the pic the black fan holder/surround is what I consider the outside of the fan. If that is mounted on the outside of the cabinet then the fans are blowing air into the cabinet. The key for good air circulation is to pull the hot air out of the cabinet. It is simple to reverse the fans. They unscrew easily and flip them over. Just easier to do this before mounting! The other key thing to note is that you need cool airflow into the cabinet as well. The easiest way I found was to drill a hole low on one side of the cabinet and cover it with a fan cover (no fan). Then mount this one at the top of the cabinet on the opposite side. I used the "SilverStone 80mm Fan Filter with Grill FF81B (Black)" found here on Amazon for $6.99. The housings look similar. This will pull clean fresh air through the cabinet from bottom to and out top. Keeps my cabinet cool and the unit moves a ton of air. Highly recommended.

Used as a "through wall" fan for my office. It is more quiet than my computer fan. I installed it in series with a wall switch, a controlled 110v outlet, and a USB DC converter. The cable and 3-speed selector is hidden in the wall. would have preferred that selector switch to be right on the fan, that would have simplified installation. But I didn't find any such product. So I am satisfied, and I can breathe fresh air.

Extrem leiser Lüfter. Stärke verstellbar. Nutze es oberhalb eines Heizkörper. Damit wird das Schlafzimmer schnell und gleichmäßig warm.

Me gusto como se puede ve el mueble donde quedo instalado, pero necesita mucho espacio entre la pared y el ventilador para poder generar una corriente que permita la ventilación adecuada.

Lo uso para refrigerar un modesto Home Lab en casa encerrado en un típico mueble de persiana de ikea. Lo instalé en un lateral del mueble sobre un orificio a medida. También hice otro agujero en el mueble es la superficie superior hacia atrás para montar una rejilla de salida de aire. Aún a bajas revoluciones este ventilador es capaz de bajar aprox. 5ºC el interior y casi sin ruido. A mayor ventilación bajaría más la temperatura a cambio de oirse más.

I purchased two Airplate S7 units to fit into a cupboard that I was using to house my two NAS units. The cupboard was getting very warm prior to installing the S7s but now it is always nice and cool. Very easy to fit and extremely quiet. This small cupboard is my lounge and the noise from the fans is practically non-existent (I have them running at the highest speed).