TCBWFY 10 Pack Garden Plant Support Stakes,10" Widex16 High Heavy Duty Interlinked Half Round Peony Support Ring Cage for Indoor Outdoor Plants,Plant Supports for Peony,Tomato,Hydrangea,Rose

Easy to assemble. Structurally sound. Visually pleasing. Height may be adjusted as needed.

I like this product because it does exactly what it says. It hugs and holds my monstera beautifully. You have to make sure you buy the appropriate length. It's strong and sturdy, easy to use and will last a very long time. I just think they're a bit overpriced.

Good construction - though the 36" ones should be heavier wire - vertical shaft will kink and buckle supporting 3'+ top-heavy plants like peonies.They push into planter topsoil well - just grab by the shaft, do not push down from the top unless soil is very loose, to avoid buckling it. NOT heavy duty enough to push into any soil with gravel - needs a pilot hole in that case (like if your plant is in shallow topsoil over a granular or rocky native soil).Recommend getting several sizes - because since there are no lateral supports midway, a tall one will not support a short growing plant, I use 16" and 24" ones - with about 1 foot of planter bed depth can push way down for short plants or initial growth, reset shallower as it grows, then transition to the 24" as taller plants (peonies, columbine, daisies, bellflowers, tall lilies, etc) gain full height.Note takes 2 pieces or more (up to 4-5 for big peonies and ostrich ferns and such) pieces to totally surround a plant - though some sun-leaners like columbines and bleeding heart you can sometimes just use a single curved around the sun-side of the plant. So when the Details page says say $4/piece, remember it takes 2 pieces to make a say 10" circle - so you go through a 10 or 20 pack pretty fast.

It worked wonderfully with my flowers in front of my house. It helped the flowers stay up and not hang or laying on the ground

Used this product to support peonies. Very sturdy and versatile. Easy to use

I’ve used these for my aloe and monstera plants. They are sturdy enough to hold up the heavy stems.

Stakes arrived in damaged box with several 2" holes. Connector pieces were not in little plastic bag, but scattered loosely in box. Some were stuck inside box to tape placed on outside of box. Amazing that none fell out of other holes not 'protected' by tape!! All pieces were present. Not all connector threads attached without considerable work. Very difficult with arthritic fingers. But, they are now all assembled and look fairly sturdy. Haven't tried to stick them in the ground yet, so don't know if they'll be strong enough. I would not order again because of difficulty for me personally to assemble.

Great product at a great price.

The metal was strong, no problems to get the “legs” into the soil. The supports should do a job supporting the branches as they grow

these are fine for small plants, like minitaure bleeding hearts, shasta daisies. they definately are not of use when it comes to holding up peonies, gladiolus, lilies, crocosmia, or anything that has heavy/large blooms....firstly they are not tall enough, and definately need to be made of a heavier gauge metal.

Facile à installer même sur des plans déjà matures

These really work to hold up plants

Spring has not yet arrived here so I have not used them, but these 24”plant supports seem to be quit stable and the right hight to support my Hydrangea bush and keep the blooms off the ground.