Original Sealing Ring for 10 Qt Power Pressure Cooker - Replacement Silicone Gasket Seal Rings for 10 Quart Power Cooker XL, PPC790, PPC773, and WAL4 Accessories Parts 2-Pack

the fit was a bit big , however compared to other seals the seal are stiffer and need some lube to seal My float valve was not working so the seal appeared to be leaking after the initial run the seal was leaking , I let cool applied some dish soap to lube the seal as it would grab to turn is the lid I fixed the float valve which was the big leak,, ran a cycle and the seal is perfect You must lube the seal on the first run or is grab and does not seal I post a pic when i can. I have found is the seal gets wet and soft is will not seal you have to let it day and start over, the 2nd seal worked just fine. I also order some float valve and pressure relief valve parts

Doesn't work, not an original part at all, although when we put the original one next to it they seemed right. The original one was yellowed and slightly larger but I thought it was because it was stretched out from years of use and removal and replacement (see photo). When I put the new one in I noticed that it didn't suction very well. I didn't use the pressure cooker for a few months and finally tried it tonight ... The sealing ring prevents the cooker from closing properly. Don't buy.

Out of nowhere our cooker acted like we over filled it with liquid. When I know we were well below the fill line! So after we cleaned up the mess, my wife says the gasket seems a little bit loose. (stretched out) So I purchased 2 of these just to have an extra. About 2 weeks After we replaced it, we Used the cooker. What a difference. It seals like new and worked perfectly. We have the “Power XL 10qt” Definitely recommend.

Waste of money , they are too tightly wrapped around the lid insert and will not seal to the pot. I have 10 Qt power pressure cooker XL. Tried flipping the gasket over. Just does not work. Had to keep using original gasket. I will order directly from Power Pressure cooker.

I have the Crockpot 10qt multicooker This seemed like the only replacement gasket available. It was tough getting into place, so I cut about 3/16" from one side of the seal and I was able to make it fit in. It works great

. problem is, it didn’t solve the problem I have to keep the steam locked in for the pressure to build. 🤔 I’ll keep them since they do fit & updates the one I have. Yet I all have to see about another way to lock in the steam. 💁🏽‍♀️

I have a Power pressure cooker XL. My original seal finally wore out so I bought this 2 pack. While trying to cook a meal I discovered steam escaping all around the lid. It was leaking past the gasket so the cooker could not build pressure. I tried flipping it over and still no seal. Though it may look the same this is definitely not the exact fit. The gaskets were inexpensive, but not worth the hassle of a destroyed meal. Without the pressure, I didn't have a way of cooking it.

Work great Durable Easy install