SW 80% VLT Nano Ceramic Car Front Window Film, 99% Anti UV Heat Insulation Sun Blocking Solar Window Tint, Transparent Blue, 20Inch X 10Feet

This product is amazing in regard to cutting down the heat without compromising vision. I put this on my motorhome to cut down on the intense heat when we drive. And it worked quite nicely. With the remaining roll I attempted to put on my car windows but due to my windows being slightly curved would not stick without a bunch of wrinkles. This is its only downfall as applying it can be difficult and creases extremely easily. But if you can get it on without creases then it’s literally a game changer. Especially if ur in the desert like I am.

Brand "SW" 80% ceramic tint 20"x10' . Very light and almost not able to see window is tinted. My stock windows are very slightly baby blue colored so this addition isnt easy to see. I did only the drivers side window. Installation was ok, but this was my second attempt, and its not perfect. If you want perfect go see the pro installer. This 2nd attempt is really nice however. Use lots of water. The old tint removed easily by just peeling it away from the glass, but the tint was in place only about 2 months. Follow the instructions, but a lot is going on when installing this stuff, so for a non-pro they should not expect pro results. Good temp reduction and i'll know soon about uv reduction (i have uv cards ready for test).

Easy enough to install. I am A mechanical type person, so super easy. However it was installed on a bedroom window that faces the morning sun. Incredible heat coming through the glass. I purchased this in hopes to cut that heat down. I maybe had a 15-20 percent decrease in heat. This stuff is pretty much worthless. Don’t waste your money here.

Used it to protect SXS windshield. its a little hard to cut and kinda difficult to install. make sure you have AS MUCH WATER AS POSSIBLE out when squeegeeing. otherwise the bubbles dont go away.

I bought this for my driver and passenger windows. it was a major PITA to install but it made a HUGE difference. I would get so hot on my drive home 40+ minutes of direct sunlight in the south. I can hardly feel the sun on me at all with this installed. I also notice my car sitting in my driveway doesn't get nearly as hot inside as it used to. Going to be buying more to do the back windows. I Found using A LOT of water made it easier. I also couldn't get out all the bubbles, but they baked out within a couple days of my car sitting in the sun.

Was not responsive to heat gun, one roll arrived wrinkle damaged.

I used it on my home windows, it was enough to do 3 windows 34" wide x 72" but because I had to cut it for the top window then another piece for the bottom window six times. The first piece turned out to be the worst and the sixth piece was the best lol. The first one I cut to match the window and because it was super hot outside the water on the window was drying before I could get the film separated, so I kept having to wet the window. The most difficult part was getting the film to separate and I wish I would've had a helper but I did it alone. The film when you are pulling the back off it will want to stick to itself and when that happens just use a water bottle with the soapy solution and spray it alot as you pull the back off or even in the area where it gets stuck on itself. I advice not cutting it to fit before hand but rather keep an extra inch on all sides and use an exacto knife and trim it after you get it flat on the window (I used a wide squeegee made for this purpose that I bought separately) By the time I got to the last window I figured out how to get the film off the back by using electrical tape lol (I am not one to read all the directions which suggests using tape) and I also began putting water on the back as I took the film off and then put it on the window vs pulling it off from under it while trying to put it on the window as I did the first time and found out real quick it was too difficult. Also the tape came in handy to hold the film on the corner of the window while I smooth it out.

I bought this specifically because of its claim to block 99% of UV rays. According to a UV detector I have at home, this film only blocks something like 70%-90% of UV - less effective than my Z87.1+U6 safety glasses or even ordinary window glass. I imagine this won't be a problem for most people, but it matters to me because (1) my skin is very sun-sensitive and gets a rash after even a small amount of UV exposure, and (2) I was planning to use this to UV-proof a surface that was made of clear PETG rather than glass, and thus didn't have much of its own UV-blocking properties.