AmeriLite for 1999-2004 Ford Super Duty F250 F350 F450 F550 | Excursion Chrome Factory Style Replacement Headlights w/Corner Bumper Corner Set - Passenger and Driver Side

Fit excellent and look great. A minor PITA to install based on Ford's design. Had to take out batteries on both sides. And then had to somehow collapse the one-way plugs Ford uses to secure the bottom-outside of the light. Otherwise straightforward install. Adjustments appear easy to reach once installed.

Very happy with the fit and quality of these lights. Good quality and they look great

The hardest part of replacing the headlights is getting the two clips that hold the lights off without breaking them. Other than that the new headlights were pretty simple to install. They look great and work awesome good luck

I put these on my 03 Excursion. These lights arent the best quality but they look good. The thing you have to watch for when installing is the cutouts where the bulbs screw in are cut very cheaply. The bulbs on both the headlight and blinker/running lights go in fine with a little more effort. Overall they are bright and clear and look way better than the old ones I had on.

Installed on a 2004 F250 Super Duty. Fit is not perfect but is close enough; had to reuse some of the old pieces (threaded plastic parts that the clips fit into) since the new ones were a little too big to fit in the vehicle holes. Overall I am pleased with the final results

The headlights look good and are definitely an improvement over the old worn ones I removed. I also upgraded the bulbs to LED, so I can't judge the light throw on it's own. I've already gotten compliments on them and would say they are a good, low cost upgrade to modernize a 2003 era F250. The install was overly snug. Where the top posts are supposed to 'snap' through the body holes, the passenger side light required some pretty extreme shoves by hand to seat one and I had to use a screw driver tip to drive the other through with the palm of my hand. The driver's side was even worse. One side easily seated the way I would have expected for all of them, but the other post required me to wrap the screwdriver tip in a paper towel and pound it in with a hammer. Unsurprisingly, the glue popped loose on one attachment point from the use of such force, but I was able to re-glue that and it works fine now. These are designed to be held in place by metal clips, so there is no need at all for them to be anywhere near close to that tight and the OEM I removed is not. I wouldn't say not to buy them based on that, but if I had it to do again I would spray them with some silicon or some kind of lubricant before installing them. We'll see how they hold up over time ... So the time of this update is four months. Both of the headlights have fogged badly in parking light and marker light sections. Since this has happened in both and only one side was a difficult install it isn't related to anything about the force to complete the original install. When I contacted the seller they suggested removing both lights, drying them, re-seating the original seal *and* adding a silicone bead to them. Much less than helpful- especially since one side was dificult to do already. No offer to replace lights that were obviously defective after less than six months. Definitely not recommended.

Don’t listen to the complainers you get what you pay for, improved my trucks appearance. Fairly easy to install if you’re handy.

Immediate improvement to the esthetic of my old F250. The fit is very close to original and the beam is clear & crisp! I hope these hold up for a while... Time will tell.

Badly glued and sealed. Side reflector flew off. Position housings filled with moisture. Only 8 months, barely 10000km .... Seller is impossible to reach.