ACDelco GM Original Equipment 10-2013 Body Joint and Seam Filler Compound - 10.1 oz

Worked great, was paintable in 30 minutes

Great product. Applies really well if you squeeze it out then smooth it with mineral spirits on ur finger

Super easy to apply and work with. Looks great. High quality, drys quick. I would buy again.

Used this to fill lap welds on a trunk floor panel that I replaced in my car. It was originally spot welded & seam sealed but I did a full length weld for strength & to keep water out. I like how it bonded to the painted surfaces and it did a pretty good job of filling but it did shrink about 10% when it hardened. Went back & overfilled before final painting & undercoating. The only problem I had was that the tube arrived damaged and was well packed in the middle of other items so it was damaged before it was packed. I am a little surprised that Amazon would pack damaged material as I have never had that happen before in 17 years of buying products from them. Fortunately I was able to get enough sealer out of the tube to finish my project but some squeezed out the damaged spot near the plastic tube so it made a bit of a mess. I suspect what is left in the tube will harden before I have further use for it so this is most likely a one shot product that should be used up within a month or two.

I love this stuff! The price is good and it spreads pretty easy and it stays where you put it! I’ve used it for years and it has held up. It keeps out water and dust on body seams.

This stuff works well and does what it's supposed to at half (or less) the cost of the competition. It's real sticky and if you get it on your hands, good luck getting it off. It doesn't go quite as far as I'd like though. Stopping part way through a tube and getting back to it a few days later is no big deal. Some products start to cure and don't stop, leaving you to throw out a partial tube. You just remove the small cured plug and keep using the tube till its gone. I've used probably 6-8 tubes and will start buying it by the case as I build more classics. Wish seam sealer was cheaper, but this stuff is as inexpensive as it gets unfortunately.

We needed this body and joint seam filler for our 1999 Dodge Ram. We needed to seal around the door hinge on the drivers side. There was a bigger gap that my husband was concerned about. The tip was bent in shipping. Too bad there isn't some sort of an extension for hard to reach areas like the one we were working on. Product is easy to dispense with a caulking gun. Product goes on thick and sets up quickly, so make sure you spread it after you extrude. We did not need to sand this, so not sure if it is sandable. It is paintable and we painted in the same day we used this. Impressed with the quality of this product. Pricepoint is what I'd expect to pay. I purchased this item full price. My opinions are my own and I was not compensated in any way for my thoughts.

Good useful OEM stuff that's hard to find this fast/easy normally