150 mm Inline Bathroom Extractor Fan with Timer

Powerful, quiet , well made , value for money , Easy peasy to wire in -no earth required just Live Neutral A second switched live ( activated when you switch on light inside shower cubicle ) Mounted mine on some foam ( kids play-mat type that you clip together ) ,just cut it to size job done . Thoughtful touches included were spare plastic tensioners for the straps that hold it to the cradle (should they break in use ) A dedicated plastic timer adjuster that is like a small screwdriver I have taped these to the fan in a bag so they are never lost and handy if I ever need to adjust timer. Overall very impressed it’s powerful , very quiet and the timer run on after you have switched off can be adjusted from zero to around 30 mins . I’m using this in really cold weather and there is zero steam escaping the shower cubicle the bathroom mirror does not even steam up and it clears any very very quickly . I suggest attaching the hoses with aluminium tape as it’s solid seals very well and is weatherproof , used by HVAC pipes fitters it’s good stuff . Also 100% recommend from me .

well packages and simple to understand instructions - a little noisy in comparison to previous replaced fan but mounting on rubber mat or polystyrene board has reduced this significantly, good flow rate is keeping bathroom steam free

Good fan, not overly loud, easy to mount due to the way the fan clips into its enclosure, which also means it's easy to swap out (or open it up to clean it, but that's a bit optimistic 😅) The electrical connector could do with being a bit bigger, it's awkward enough getting flex in there without ferrules.

In-line extractor fans I feel are so much more effective than standard extractor. This was a replacement for a previous In-line fan which sadly packed in but hadn't realised until the steam in the internal ensuite wasn't being removed. This new fan is a larger and even more effective than the previous one. Relatively easy to fit and amazingly quiet. Very good price for a quality product. Would recommend.

Great fan at a good price. Easy to wire up. Instructions in the box and online if struggling. Like the adjustable run on time.

Installed to remove steam from a shower. Best features are: Removable leaving all ducting in place, so great for future servicing/replacement. Quiet running. Integrated overrun timer. Dual speed. My experience: Works well and is fairly quiet though I mounted it onto a beam and sound is conducted to the house so I will remount onto a foam pad to silence it completely sometime. Sound is not intrusive though. There are some reviews mentioning water getting in to the electronics but it is down to how you mount the unit and the ducting you use. This time I mounted it vertically with minimum amount of ducting, venting to a vent tile in the roof. I would say avoid uninsulated ducting as you will get condensation inside which will lead to water ingress, especially in winter months. Keep the runs short as possible and with a slope so condensation cannot pool in the pipe. Better for any condensation to run back into the shower where it is already wet rather than anywhere else, though I see no water as the 30 minute overrun probably dries it all out. The low speed doesn't seem to be much slower but is a little quieter than full speed. To reduce noise especially for night time, I wired a relay into the unit so it runs full speed when the bathroom light is on then low speed for 30 mins when the light is turned off. Seems a good solution. You should definitely incorporate an isolation switch so all lines can be disconnected for servicing/replacement etc. Good product - would buy again.

Easy to install. Seems to work fine. Warranty registration a bit bothersome - it's on the Blauberg site (so this is a Blauberg fan, which I'd guessed) and requires the serial number which I can't find on the box or paperwork, so will have to climb into the attic again for it. Note that the noise level per the fan rating isn't what is shown on the Amazon listing (others have commented on this), but it seems quiet enough.

It’s a Blauberg Turbo-E fan with a different label. All the documentation is the same, QR codes take you to the Blauberg site as well. If you’ve used Blauberg products before then you’ll know they make quality fans and I’d be happy to buy again. As far as fit/assembly, it’s all straightforward with a removable motor that makes wiring and maintenance easy. Timer was easy to set too. Mine has been set up to work with the Thinkbee RF switch with a light.

لا يعمل

Gran flujo de extracción de aire pero en mi caso, nose si por defecto de fábrica o es que esta diseñado así pero por las uniones centrales se escapa gran cantidad de gases, humos o lo que estés tratando de extraer, con la consecuencia de que se te llena la habitación de lo mismo que tratas de extraer. He pedido otro nuevo por si acaso es algún defecto (aunque no lo parece y tiene toda la pinta de que está mal diseñado) y si vuelve a pasar, lo cancelo de nuevo.

Après plus d'un an d'utilisation elle fonctionne toujours à merveille.

Cumple con lo mencionado y muy silencioso

تسحب الهواء بشكل جيد ولكن صغيره الحجم وبلاستيك خفيف