iKKEGOL Pocket OBD2 OBDII Full 16 Pin Male to 3 Female 1 to 3 OBD Cable Splitter Converter Adapter for Diagnostic Extender

I'm using this as a breakout box. I do not recommend using for anything above 1 amp due to the thin wires inside.

Much more convenient than the ones with the cables. Not to mention this one has 3 ports instead of 2. I was worried it would stick out and be in the way but I haven’t even noticed it being there. I run an ELD and an engine monitoring system in it and it works great with both running at the same time.

I believe this product could be more useful if the 2 side connectors were moved out some (even 10 mm). As it is, I could not plug in my OBD2 Bluetooth and other dongle on either side connector. This rendered it useless. It the side connector were further out, it would be useful. My car is a 2012 Malibu for reference.I like the small package. Other adapters use longer wires which might make CAN communication non-functional. I've also seen flat wire extensions. I'm not sure how those even work; CAN needs twisted wires. This small package should work even if the wires aren't twisted inside.In the end, I will probably keep this and try to modify my car slightly to get it to work with my devices.

I needed an outlet to monitor my performance and temps while 4x4 in AZ summer, and a place to hook my dash-cam, and leave a spot open for my emissions test. Solved my problem.

I wanted a smaller OBDII Splitter and this worked perfectly. I read a review that stated that the female connector should be on the wide side and I agree. I realize that it might not be better for every vehicle. It would be much better on my 2016 Grand Cherokee.Well made and again simple to install. I needed 2 OBDII connections and I like that I still have an open connector if codes need to be pulled.I do recommend this.

Tried plugging in my mobile Hotspot and my Bluetooth diagnostic adapter and only the Hotspot works the lights on the diagnostic adapter work but does not communicate with the ecu making it useless but if you're trying to power a dash cam or something with this I'm sure it would work

So far this is a very good OBD 2 cable splitter that gives you 3 ports.

This caused my 2015 Jeep Grand Cherokee to short circuit. The vehicle was driving fine and then all of sudden the dashboard went crazy. It said that the shifter and the transmission needed serviced and to pull over immediately. Had vehicle towed to dealership. Dealership had to clear over 50 communication error codes. Found no issues with the vehicle after clearing codes and removing the device. Was kept over night at dealership and tested the next day again. Vehicle is perfectly fine now without device plugged in. Dealership said to NOT USE as it's been identified as the cause of the problem. Completely ruined my work day and cost me close to $500 total from tow, ubers, and then cost from dealership while issue was addressed. Extremely unsatisfied with the product, DO NOT BUY!