Beduan Stainless Steel Cast Pipe Fittings 90 Degree Barstock Street Elbow 1/4...

Quality Fitting worked perfectly for my needs. Fast Shipping. Thanks

I bought this right angle connector to use for my air line in my attic to the main run of my pipe. Works perfectly, threads are cut well and solid piece of stainless. Overall works well and does the job well. Not much more to say than it does what is supposed to do with flying colors.

Amazing product for diy projects recommended. And will buy more for future projects

I purchased this elbow for use the V-Twin breather oil collector, which I also purchased on Amazon. This fitting proved to be too large to fit under the collector’s air filter. I had no other use for the fitting, so I returned it. This by no means is a reflection of the quality of this product. The quality is first rate. It is just the purpose I had in mind for the product was so specialized.

My review rating is for the fittings themselves, which are well made. Nicely machined high pressure extreme temperature parts. My particular selection was for 1/2" street elbows, that come in a set of 2 in a plastic box to keep them clean and prevent them from dinging up the threads. Problem is that these plastic boxes don't survive transport in a shipping bag. The fittings shattered through the plastic boxes and were loose in the bag with pieces of the boxes floating around. Fortunately, none of the fittings were damaged, all the exposed pipe threads were still good. So kudos to Beduan, the fittings manufacturer, but these need better support/padding when being shipped.

What can I say stainless steel nice

Is a pipe fitting what do you expect. The square edges make it easy to install without messing up the threads. You will need to put thread sealer on it but it won’t leak. The treads are cut correctly . Most of all it looks good and presents a quality finish.

Although this piece looked precision machined, for some reason, would not completely seal connection. Ended up having to Teflon tape wrap along with Pipe Dope and tighten the heck out of it to finally get drip to stop... Note: This was added to an existing junction (that wasn't leaking at all) in order to better route SS flexible tubing. Issue almost seemed to be a tolerance issue... However, it finally got to being leak free, after three tries and hopefully is done now...

Ne sont même pas egale un est plus court et un est percer plus que l’autre…. Sa serait tu possible dans avoir deux identiques??…

Seems to be a quality item that is machined well.

The fit to a Beduan 1/2” NPT pipe is very sloppy, requiring excess Teflon tape to seal the joint resulting in a leaky and misaligned fit.