Permanent Valve Stem Replacement Kit | Heavy Duty Metal Emergency Valve Stems for Tubeless Tires | Quick Install from Outside of The Wheel | Made in USA from Quality 360 Brass Components

These things really work! Our aftermarket TPMS system was causing the rubber valve stems to flex and contact the wheel at highway speeds.These seen pricey, but it was much less expensive than having the tires dismounted to install conventional metal valve stems.Installation was very straight forward, easy and fast.

As the title says, these things work. I had an old, crusty valve stem on a tubeless tired used motorcycle I purchased. After about a year, it suddenly developed a catastrophic leak through the cracks in the valve stem, leaving me stranded temporarily. I didn't feel like paying tons of money for a shop to remove the tire and replace the valve stem, and I didn't have the means to remove a tire at home easily, so I figured I would give these things a try after someone recommended them on stromtrooper.com. What do you know? They work great, and they're dead easy to install, even without removing the tire. I tried to remove the old valve stem as best I could with some needle nose pliers and a flathead screwdriver and managed to get most of it out from the outside of the rim. Some pieces did fall inside the tire, but I haven't noticed any negative effects from there being a few small pieces of rubber in the tire. I put this thing in the rim, tightened it down, and voila, solidly sealed tire. This nicely machined replacement valve should probably be the default valve as it works, is easy to install, and is made of metal, not rubber. I pumped the tire up and it has held the same psi for about a month now. Very satisfied. Also, made in the USA.

Great Setup and it Worked on my Water tank!

you can’t beat this if you can’t get to the back of the valve for whatever reason. It simply bolts in and effectively does the job. I think it’s about 10 bucks too expensive, but it is a quality product. they are selling as a pair, I would like to see them sell it as a single unit to reduce the price.

These are great and really come in handy if you are in a pinch and need to get up and running again.

The valve doesn't fit for me. It is high quality super easy and fast to install with the tire still on. Unfortunately with it not being flexible it interferes with my beadlock ring and can't be aired up. I like these so much I might drill a large hole in my beadlocks so I can run them. A must have in an emergency tire kit. I used it in a pinch with no other choice and only turned the nut a couple times(not even close to tight.) Then king it a few degrees And it still held air and I was able to get off the trail and drive home.

Works great. Installed on a John Deere bunker drag.

Very high quality and easy to use highly recommended worked perfectly