LavaLock® clamps compatible with Oklahoma Joe's Smoker Lid Latch Kit for Longhorn, Highland, 3 in 1 cook chamber lid 2 pack

Easy to instal and works great

Works great. Wasn't hard to install. Just make sure you have drill bits for the project. Otherwise its going to be one heck of a project.

Works great on my Oklahoma Joe’s Longhorn smoker! No more leaks! The little red handle does slide off, but I put some of the sealant caulking in it to keep it from slipping and it stays in place. No biggie…

These LavaLock clamps are a must-modification for any Oklahoma Joe Highlander/Longhorn Smoker. They are a tremendous accessory that goes far in leak-proofing your new smoker. I lined the clamp up with the top part of the handle bracket. Then using a silver tipped marker, I marked the four holes. After center punching the marks, I drilled a 1/8" hole followed up with a 3/16" drill bit. The included hardware is 10x32x1/2" bolts and they fit perfectly. The only thing to keep in mind, check the back side for the weld spot. You will need to shift the clamp a bit so it doesn't fall on the weld bumps. These LavaLock clamps really work and one of the must have mods to do. I highly recommend them. I give the clamps ⭐⭐⭐⭐⭐ and bet you will too! Thanks for Reading - ✌😉

These worked quite well!

GOT THEM BUT HAVE YET TO INSTALL THEM WILL DO THIS COMINGING SPRING

Arrived with hardware. I have attached to lid and its shuts it up tightly.

The bolts/nuts supplied are not long enough to go through both the cook chamber metal and the piece welded in to make the door seal. So the two bolts closest to the opening will have to be replaced with longer versions or like I used self tapping screws (pre drill the hole). Didn't come lock washers so we'll see if with all the heat/cool cycles if they stay tight. They do help with that Oklahoma Joe's longhorn lid problem of not sealing good because the door is catiwompus. I do have gasket material on my door also. You can see in the video that the door is still leaking. Albeit not as bad. The video is with the pit just fired up so there's plenty of dirty smoke making it easy to see the leaks. I'm all yes the clamps work and do help. You'll need a little ingenuity to get them fitted.

These work well. Very happy with them.

bon

This is a low quality latch, not close to what expected at all. I had to add clamps for each to keep it from fell apart while instal it because it happened before I start to use it. Not recommend it and don’t spend your money in low quality products 👎🏼

Exellent mod for your ok joe, simple enough to install with a couple of good drill bits. Use with a gasket kit to get a good seal.

Trop petits