Super Alloy 1 Full Kit 3/32

Wow, funny name but this stuff really works awesome! I had a highly cosmetic zinc investment casting for a point of purchase display that went wrong and I was able to 100% fix the issue and save the parts! Super easy to use. Blends with the zinc so well that I can't even find the places I fixed to be able to brag about it! Stunning results in seconds! I wish it came in smaller diameter tho. Going to run these thru a pull plate to get them down to a size suitable for my work piece without so much waste

Works as advertised. With a little practice, all is ggod.

Had high hopes for this product but it just doesn't work. Won't stick to material regardless of how you prep, heat, flux, etc. Followed instructions but it was no use. Don't waste your time or money on this stuff.

Expensive, long delivery time, didn’t quite work in my hands for brazing… probably needed TIG for my project. Your mileage may vary

I was trying to secure galvanized pipe I bought to ordinary steel plate. I used the enclosed flux to wet the surface of the steel plate and coated it using a torch with 50/50 solder. Then I coated the galvanized pipe with the same flux and heated it. Put a tin coat of super alloy 1 solder on it and mixed it with the 50/50 solder. Seemed to secure it well.

It is acgrest product

I used the product for repair pot metal parts for a car. Didn't really come up to the standard I was expecting. I am no dummy when it comes to welding or soldering, not a pro either. I have been an engineer for many years and I could not get this product to perform according to the vids. The primary problem was when the pit was prepared as suggested in the video and the solder applied, cooled, washed and then sanded or filed back there was always a void or voids in the weld. No plater will accept that. However I used the solder to weld stainless tabs to a headlamp frame. That worked fine.

I really liked the product.i bought a scraper for cutting out the inside of boxes made on a wood lathe.it didn't come with a handle,so I made a handle on the lathe.i molded a piece of brass to fit around the metal tang.it wasn't closed all the way,and it keep the handle from splitting,so there ya go i used the muggy weld and sealed the brass together wonderful job.