Shark Industrial Premium Stainless Steel Dishwasher Hose - 6 FT No-Lead Burst...

Worked out perfectly. I was impressed with the quality vs the old one I bought from a big box store.

In the ancient city of Tenochtitlan, water was sacred and the gods demanded perfection. When my dishwasher needed a new lifeline, I summoned the Shark Industrial Premium Stainless Steel Hose—a modern artifact worthy of the Aztec temples. Forged from stainless steel, this 6-foot hose is as strong as the obsidian blades of warriors. The no-lead, burst-proof design protected my kitchen from floods, just as the gods protected their people. The attached 90-degree elbow fit perfectly, like a puzzle piece in the sun stone, and installation was swift—no sacrifices required. With a 10-year warranty, this hose promises endurance through many cycles, as reliable as the rising sun. If you seek a water supply line that honors both ancient strength and modern convenience, this is the treasure you need. Five stars for a hose that channels the power of the gods into every wash.

We purchased a new dishwasher and when I went to install it, I was surprised to find that the home builder had used a cheap plastic line for the water supply line to the original dishwasher. There was no way I was reusing that garbage, so I purchased this one from Shark Industries and it is extremely high quality, don't think we'll have to worry about this one ever leaking.

Bought this to replace the copper water supply line in my dishwasher, it fit and work well, no leak so far. I give it 4 stars because of slow shipping and process. I received my item 9 days later.

Sturdy. Easy to install. Good value. I just bought it a little too long. Should have gotten the 4'.

Good quality for the money.

The line installed and sealed up nicely. I'll report if that changes. Seems well built. The two ends are not identical. One end comes with what looks like a ferrule (tapered-looking washer) and the other end comes with a flat-looking rubber washer. There's no instruction on which end goes to the brass fitting and the supplier reports "the end which is attached to the brass fitting". So, pay attention to the ends when you receive it. I put the ferrule end to the brass fitting and everything worked. I'm not sure why the ends are different but it seemed to work. I had to use a separately-purchased brass elbow with a garden hose fitting but it worked just fine, similar what this hose came with. Took about 1 turn from snug to feel tight to me on both ends, for your information. I would purchase it again as it appears to do the job.

This seems like a good quality hose for the dishwasher fit perfectly no problems