Donner Noise Gate Pedal, Noise Killer Guitar Pedal Noise Suppressor Effect 2 Modes for Electric Guitar and Bass True Bypass

This is a great little pedal that does the job as well as something three times the price. It’s essentially a noise gate - got an annoying hum in your amp? This will allow you to set a level at which any sound below it will not make it to the amp. Thus, quieter operation.The housing is metal, strong and robust like all of Donner’s range that I’ve tried so far. Really simple to use - just put it in front of your amp and dial the large knob until the noise is gone.The hard/soft knee switch is a nice touch and makes a noticeable difference. For those unaware of what a ‘knee’ is in terms of sound dynamics, it’s a setting that dictates how quickly the noise gate reacts in pulling the signal below the set threshold and then rereleasing it back again. Harder settings are faster but can be more abrupt, lower is slower but can leave slight tails of audio etc. There’s no way of setting this but it does work.I’m not sure of the validity of the true bypass claim as I’m using it in one of the loops of my ES-8 switcher at the moment.A great little peddle for those on a budget or others that just don’t want to spend a fortune to keep their amp quiet. Highly recommended.

I had finally got round to building my pedal board.I had been collecting pedals over time and when I'd come to play, I was getting annoyed with the time it was taking to set them all up. Then I'd forget cables, power supplies, etc., and end up annoying myself.My mates had been telling me over and over to build a pedalboard.So, I got a board, and went about assembling the six pedals I though I had, to discover I had nearly double the amount. Yikes!Anyway, once built, isolated power supplies used and quality patch cables utilised, I was still getting noise.I have a couple of different overdrive and distortion pedals along with a boost pedal.If I want to go from clean to overdrive, I'd naturally incorporate some noise.So I asked my mates and they said to stick a noise gate at the end of the chain.Did some research, and this little box came up at about 4th on most lists and the price was right brand new on Amazon. I'd seen good reviews for other Donner pedals although never owned one so: Click, Click and it was ordered.It arrived in a couple of days. Boxed. Nothing really fancy about what you get: pedal and short instruction sheet, but what do you actually need?Stuck it on the end of the chain after the boost and it just works. No noise.The only pedal it can't tame on my board is a Blackstar HT-Distx, but that one's such a nasty beast of a pedal, if you're using it, you've just got to expect you are going to make noise.So I'm well happy with it. It's tiny as well so takes up little space. There's rubber on the base that has to be removed to get velcro to stick to the pedal board, but that's nothing new. It's solidly built and easy to operate.All in all, a cracking little pedal. Did exactly what I hoped it would do. Nothing more. Nothing less.

Bought as a cgeap replacement fir my boss noise gate. Its Good for the price, but struggles to gate high gain compared to more premium pedals ive had before

My son's electric guitar "noise" was very noticeable for the high level of hiss and crackle that came from his amplifier, but this Noise Killer pedal helped to reduce and clean that up.The pedal is made with a metal body, and has a bit of weight to it, despite its compact size, and a kind of foam rubber base to be non-slip. It came on it's own in an attractive small black cardboard box. You will require a couple of other items for it to work for you:A "center negative" 9volt 1amp power supply is required to power it.A patch cable to connect the output to the ampThere are three ports, the power port is at the top (in relation to the picture of the pedal), the right side of the pedal is the input port from the guitar. The left side port is slightly below centre and this is connected via a patch cable to the amplifier.We tried to balance the guitar output with through this noise pedal once it was all hooked up. and this is done via the black knob. With it set to the lower left all the guitar output plus hiss and noise passes through. By gradually rotating the black knob clockwise, you can hear the change in the level of hiss fall. If you do this to the point where the hiss disappears and no further, that would be the level you use the pedal at. If you rotate it fully to the right, all the guitar output is cancelled out, so there would be no output signal to amplify.We found that the volume and tone settings on the electric guitar was important as this fed through varying degrees of noise. You have to play with it to find out where to set it for your session. Overall, we're very pleased that we can have a clearer output during guitar practice.

I moved my music gear to a different room in the house and maybe there is an earthing issue. However, the result was that after moving, I began experiencing a horrible pounding noise from my amp when playing my Telecaster using a distortion pedal. Only the Tele, only with distortion, so clearly "noise" from the single coil pickups. So I bought this Donner noise gate. Put it on the board, adjusted the knob and BINGO - noise gone! Inexpensive, very well packed, and delivered within 24h. Can't fault that.UPDATE. After about 2 weeks mine stopped working properly, led light no longer functioned and when turned off muted my complete pedal chain. Returned.

Good bit of kit, works really well. Helped me dial out the earth hum, until I bought a new power bank which totally fixed my issue. I still use it live though, cuts unwanted noise dead. As with all noise gates, you have to play with it to get the right amount of sustain, or it will drop off to fast.

Very good,I always trust Donner, the noise gate is very sensitive with hot active pickups.

This is an inexpensive noise gate and does the job perfectly, lots of more expensive models out there but for me at this price point it’s a no brainer. Been using it to silence a compression pedal for recording, I’m really happy with its performance recommended

Smidigt format, lättanvänd och gör sitt jobb

シングルコイル特有のジーというノイズが消えてお値段以上の価値があります。BOSSのNS-1ような高性能ではありませんが必要十分です。

works ok but after some time it dident seem to cut the noise for some reason, it may one of my batteries loosing power so ill try it out again later

Hab das Teil gerade ausprobiert und es macht was es soll und das ohne groß etwas einstellen zu müssen!Die Verarbeitung ist super und der Lärm wird definitiv gekillt!Wirklich ein geiler Noisegate für n schmalen Taler!

Pedal de puerta de ruido imprescindible en cualquier pedalera de guitarristas y bajistas, funciona fenomenal a un precio irrisorio, no hay necesidad de comprar caros pedales si este te da lo mismo. Totalmente recomendado.