Briggs & Stratton 699374 Fuel Tank

I mean it is a fuel tank, it is Briggs and Stratton, and it fits my power washer.Installation was mostly painless, but one of the screw holes on the ring was a touch out of place. I was able to get it to line up but it was a little bit more of a pain than I had wanted. Installation and reassembly probably took 20 minutes, even with putting the new fuel line in.This one replaced the original that had enough JB weld and tank repair on it to choke a horse, but it kept leaking and when I am going to be setting it in my front yard to start stripping paint off the eaves of my house, I don't want gas to leak into my grass.I filled it with gas, and it doesn't leak. Did put in a new hose, and new clamps, but it seems to be doing good. I used it some last night, and refilled the fuel tank, and this morning it still was full and no signs of leakage.I do have to say the elbow coming off the bottom of the tank for the line, it doesn't feel real sturdy. It may get some reinforcement in the future, but it works great and I was able to run the power washer to get ready for my next major project.

good quality gasoline tank replacement. fit my lawn mower perfectly and install was very ez.

Fit was perfect. Lost some of the look of the original due to covers were made onto the original gas tank. But it is a 20 year old wood splitter and the tank doesn't leak. 10 minutes to install.

Appreciably less expensive than offered years earlier, and most likely by a different vendor - I just don't recall. At the time my solution for the split tank was to just fill below the crack. Checking now and finding this option at the lower price prompted pulling the trigger now. Quality is oem level, and fit is perfect. It has resulted in now NOT having to replace an otherwise perfectly operating mower.

I had read that the original gas tank was susceptible to cracks and leaks, and sure enough, mine did. I was able to remedy that with J-weld, which worked fine for a year, and then fell off. I was able to re-apply the J-weld and it worked fine again, but I decided to purchase this new tank anyway, so as not to have to deal with the crack any longer. It fit perfectly, which was my biggest concern, and is easy to switch out with the old tank. The only thing I wish it did come with were the 3 mounting screws, as I had lost two from the previous tank. I made due with screws I had, but it would have been nice to have the mounting screws come with the new tank.

Worked perfectly, husband is so happy 💕

Genuine Factory part, Well packed! Effortless change out.

All good.