STEPPERONLINE 5PCS Nema 17 Stepper Motor Bipolar 2A 84oz.in 48mm 4-Lead for 3D Printer/CNC

The stepper motors are rated at 2A where most others are below this current level. I have used them without any issues. They run very quietly. I am using them in a CNC wood mill. I recommend these without any reservations.

Finally got to play with these things today. Really, just had time to put the ramps and arduino together and hook 'em up. So far, they work just fine. Other reviews mentioned a lack of connectors on the wires, which I had prepared for by purchasing a pack of dupont connectors and a crimper for them. These things had connectors on them, apparently compatible with RAMPS 1.4. A minor downside (nothing to write home about, and likely specific to the application you'd be using these for) is the cables falling around like noodles after you untie them. Definitely a good purchase. Might end up getting more.

So far it's a good little motor, however the low 1.1ohm coil resistance is causing me some issues with one of the L298N H-bridge modules I also bought off amazon. In order to drive this motor you either need a current limited power supply <2A or you need to drive it at about 2V. If you supply it with 12V as stated in the spec sheet, it will draw about 11A, which is plenty to smoke-check both the motor and your H-Bridge. If you're going to use this with the L298N, you must use PWM, or wire 4-8ohm@5W resistors. If you don't know what any of this means, don't use it with the L298N modules you will end up smoke checking the motor or the bridge.

Great Steppers, worked wonders for a 3d printer. Plenty of power and great accuracy for the job. OSM also has additional information about their products on their website so you can properly match a driver/controller and power supply with the stepper motor. My only complaint is the wires are free floating with no organization once so ever, and no I’m not a big fan of spaghetti wiring, nothing a little heat shrink won’t fix but still. Also others may want to know that these come with no connector on the end of the wires, which to me is understandable and I don’t care, but you might.

Unos motores demasiado buenos stepperonline lo mejor de lo mejor

I bought a bunch of cheep steppers somewhere else to get started but the first thing I noticed was how loud they were but what’s worse was the heat. I bought these to replace the cheep ones and I sure glad I did. These run so quiet and cool especially with TMC drivers! I’ll be ordering more!

Works perfect, much better than the original motors I had. Only issue is they don't have a plug to make rewiring cleaner. Also the wires coming out of the motor are all independent, so it makes it messy to keep them together. Those are just my OCD issues, not a knock on the motors themselves though.

I bought a five set of these steppers back in june 2019, and after finally testing them, I found one of them to be defective, it vibrates heavily and jerks about instead of moving smoothly. update: After calling customer service, their response was immediate, sending a new replacement stepper motor immediately, not even requesting that I send the old one back. They were very helpful, and I plan on buying from them again in the future.

Stable motors, strong, never had any issues. Delivery was good too 👍🏻

Decent product, as described.