120mm 12V 0.45A 2Pin DC Brushless Cooling Fan 12 Volt 120x120x25mm | High CFM 5 inch Exhaust Fan Motor, 3000 RPM DIY 2-Wire Replacement

Bought this to replace that fan in my 850w NZXT brand PSU that I've had for maybe 11 years now. My original fan had developed a rattle. I didn't want to replace the power supply as it was fine otherwise. The specs for my fan were 0.5a and 2500rpm. This fan was the closest I could find on Amazon to the original spec. It works perfectly. Even though it spins a bit faster it is pretty quiet. No louder than my original anyway. Solid buy.

Great value for the money. i have purchased many of them in the past

Works well. Used for pulling heat from camper's electrical cabinet. Good airflow for its size. Noise is not too bad.

I bought this fan to see if I could fix a portable dehumidifier. It turned out to be a circuit board failure, so I didn't need it after all. However, the kit is well equipped, that fan seems to be decently made, and the harness connector fit properly.

I use them on arcade games. They move there as they should. 12 v conductor connection. Keeps my cabinets cool and vented and I don't even hear them.

Work great in my indoor ikea greenhouse. Very quiet. Assembly was easy but my husband is an electrician.

Perfect replacement for my GE Opal Ice Maker. As per instructions, this fan is slightly louder than the original, but not enough to make any difference considering where the ice maker is located. It is louder due to the 3K RPM rating which is fine with me because it operates at faster rotational speed (CFM) than the OEM version which makes the ice maker more efficient and produces ice a bit faster. The only anomaly is the power connector is not compatible with the controller board on the ice maker. I simply cut the old connector off the old fan and replaced the new connector on the new fan by soldering (blk to blk and red to red ) and using heat shrink tubing to protect the bare metal wire. You could probably use wire-nuts as well, but I prefer soldering.

I needed 4-pin fans for a PC build - now here I am a few months later looking for quieter ones. (Update) At full speed, the fans reach 2560 - 2580 RPM (Spec says 2500) But the blade design isn't allowing for maximum air movement - so they are making more noise than they should be Oddly enough - I think the airflow direction arrows are missing? This is really a bad show in my opinion. I may try to lift them off of the case grill as this could be causing air friction. Update - The manufacturer reached out and offered a refund, which I declined. Nothing 'wrong' with these fans, they just need some updating / fine tuning.

Works great, moves a ton of air. Is louder then the fan it replaced but it also moves more air.

Strong airflow, low noise level, amazing quality, multiple functionality and fits perfectly. Highly recommend.

Simplemente no funcionó, lo compré con exactamente las mismas características del ventilador anterior y éste no sirvió. Se devuelve.

Bon produit ça a bien fonctionné

Working and doing the job they were purchased for