Silicone Skin Case Cover Protector for iPod Classic 80GB 1st, 120GB 2nd, 160GB 3rd Generation

Arrived on time, fits my ipod classic snuggly as i had hoped.

Does exactly what it says on the tin I

Was after a case ideally like my previous one (unknown brand) for a 4th gen 80gb ipod (slightly thicker and heavier than a new 7th gen 120gb) that I bought this for.The other case was a durable full wrap silicone case with a clip on plastic screen protector. The wheel part was slightly thinner silicone (but still part of the full 1 piece wrap) and although offered some resistance was usable and fully protected the ipod minus the charging and earphone socket.This case was the nearest I could get without having a massive gap (much wider than the charging port) at the bottom or belt strap cutouts on the reverse like other cheaper variants from elsewhere.This case fits tight without any of these issues. It fits the screen well with a minor gap (99.5% good) along one edge as it's rounded corners (I'm being picky).It feels durable and sturdy. I bought the red colour which is very bright and as pictured.I thought I was only getting the case and had looked elsewhere for wheel covers to protect the wheel from oils etc. but couldn't find any suitable and certainly not cheap.Despite not being advertised my case also came with a thin slightly textured outer and inner circle sticker for the wheel to protect it. It also came with firm silicone protectors that easily push into the exposed ports for earphones and charger.These make all the difference and give me the confidence that this is as protected a case as I can get for this model.I only got this to protect the ipod from oil if in use whilst sunbathing etc. and not to protect it from falls. I doubt it or any other case would offer protection against falls this since it's essentially a hard disk but it should stop general use scuffs etc.I thought it seemed a bit expensive at first but the extras, although small, do make up for it and there's even a spare of each. The cut outs are the right size and in the right place. It's a little hard to use the hold button but this is normal and because it's fully surrounded so is expected. There was also a screen protector which I am highlybused to fitting although I remember this not being so clearly labelled as to which side was sticky.As with my previous case, silicone can be cleaned (for dust etc.) by just running it under the tap and shaking it dry. I think when compared to my other case it is more slippery or less resistant when holding in the hand but not to the point where you're likely drop it. As mentioned it's a tight fit but not too tight to be hard to put the ipod inside.It's not a brand I'm familiar with and when chosing phone cases I normally stick with the clear silicone spigen brands but couldn't find any to fit my ipod.Overall I'm very happy I chose this and recommend it.

Just wished I'd made My Swap a Few Years Sooner!