Bernzomatic® Bronze Flux-Coated Brazing and Welding Rods - Four 12 inch Rods for Everyday Repairs of Steel, Cast Iron, and Copper Metals; Working Temp of 1,595° to 1,630° F

I used this product to put back together the peacock in my backyard. It broke at one of the legs. I was worried that it would not hold up the weight of the peacock and the big rock, but it worked great and it’s still holding up and just spray-painted a little over it. Great product and easy to use. Thank you!

Great deal quick shipping

Always need braising rods for project & this works fine.

I repaired my wheelbarrow! I needed MAP gas to do it. Regular propane was weak at getting a good melt.

Worked very well on the steel floor repair on my truck. Very satisfied

Fairly priced

followed instructions, but even when the part is red hot, the rod just doesnt melt. I use map gas and heated for over 15 minutes.......really hard to use. Additionally, its not 1/16 inch, its 1/8 so its harder to melt. i might try crushing and flattening it before feeding it next time....I have over 3 1/2 rods to use. Only needed about a half inch of rod. Please send me the 1/16 rod!!! I am sure they will work much better.

Needed this to repair a leak on a Viking stove gas line.

I USED THEM FOR THE INTRICATE FOLD'S,, AND CREASES OF MY EXPANSION-CHAMBER FOR MY SKI-DOO,, IT HAD RUSTED IN THE WORST SPOT'S,, BUT THANKFULLY THESE BRAZING ROD'S FLOWED NICELY INTO THE DEEP CREASES,, AND FOLD'S OF MY EXHAUST,, WITH MINIMAL CLEANING TO THE METAL,, BECAUSE OF THE HARD TO REACH PLACES.

Product as described

I'm thinking more like 99% Brass is more likely. But They work very well and the flux makes for great adhesion.

hard to work with

Good value.