Monstrum Tactical Low Profile Picatinny Riser Mount with Quick Release, for Red Dots, Scopes, and Optics (0.5 inch H x 2.5 inch L)

Durable, reliable. When reinstalled, it falls into place. Thanks to the springs it is easy to install, very useful. All good, but not light weight.I would take off a quarter star, but there is no such option)Remember that it is up to you to wear it and the lighter it is, the easier it is...

The low price and easy to install and remove nature of this riser makes it a really solid choice in my opinion. The latch to tighten it is super great in comparison to a hex screw or the like, Being able to quickly take it off is nice if you want to swap between say a Foregrip and a Bipod on the fly. I used it for Airsoft but this definitely would hold up decently on a real gun. For the price, this isn't half bad. It's cheap, easy to use, and durable. Can't ask for much more than that.

This is a good solution, but I'm sure there are better ones...but you will pay more. Installation was easy. What you have to keep an eye on and what you might struggle with is finding the perfect tension for the clamp. For me, it was a very small window between too hard to close and didn't feel tight enough. Depending on how you use it (frequent on/off vs leaving it on), you might have to fine tune the tension.Overall, I would consider this a good solution, but no perfect.

I needed this to raise the red dot on my SBR. The size was perfect. The fit and finish were exactly as expected and it mounted with zero problems. Adjusting the quick release was very easy and didn't need any tools. I loosened the screw, put it on the rail and then closed the lock. Since it was very loose I could turn the screw with my finger until it was snug. Then I opened the latch and tightened it a half turn. Closing the latch was much stiffer and it locked just as it should. After shooting 100 rounds through the gun the mount didn't loosen or shift. The zero on the red dot didn't change between being mounted directly to the rail or on the riser. This is well worth the money and when I need another one I will specifically look for this brand.

I bought this to add QD capability to my PA 1x acss prism optic and it definitely delivered. Hundreds of rounds shot and it didn’t lose zero or fall off. Definitely recommend putting some loctite on just in case.

The mount seems solid and mounts to my AR very well. I attached a red dot to the mount using it as a riser so it will cowitness with my flip up iron sights. However after taking the mount on and off a few times the roll pin that holds the cam lever on has become loose and falls out, causing the cam lever to fall off. The mount still works, it's just a pain because unless you hold the pin in the hole when there isn't tension on the cam lever, it will fall out.

works amazing 👍🏼👍🏼

Great riser and just what I needed. I was a little skeptical about if this was the size I needed and if the quick latch would work out and it was perfect. You adjust the other side of the latch with a screwdriver to get the tension that you want/need and then lock the latch. My optic and magpul sights cowitness perfectly now.